Miele CVA 5060 Operating And Installation Instructions page 65

... there is a lot of residual "coffee
water" in the waste container.
If the slide control for the grinder is set
to too coarse a setting, too much
residual "coffee water" can be left in the
waste container.
^ Set the grinder on a slightly finer
setting (see "Setting the coffee
grinder").
^ If necessary, adjust the amount of
coffee (see "Settings: Customising
your machine - Setting the amount of
coffee").
Is the cap correctly attached to the
central spout connector (see "Guide to
the machine" - "Interior view")?
^ Lubricate the cap on the central
spout connector with the silicone
grease supplied.
^ If the cap is missing, replace it with
the cap supplied with the appliance.
... the descaling programme was
started by mistake.
The descaling programme cannot be
cancelled once you have touched the
OK sensor. The programme has to be
completed through to the end. This is a
safety measure to ensure that the
machine is fully descaled, and is
important for the long-term protection of
the machine and to ensure it functions
correctly.
^ Descale the machine (see "Descaling
the machine").
Problem solving guide
... the coffee machine makes loud
noises during the descaling
programme.
During the descaling programme you
will hear loud noises as water is flushed
through the machine under high
pressure. These are no cause for
concern.
... the heating-up time is getting
longer, the amount of water coming
through is incorrect and the machine
is not performing properly.
The machine needs descaling.
^ Descale the machine (see "Descaling
the machine").
... no water comes out of the central
spout.
The filters in the brew unit are dirty.
^ Remove the brew unit and clean the
filters with your finger (see "Cleaning
and care - Brew unit").
... the brew unit or the waste
container cannot be pulled out of the
machine.
The brew unit is not in the correct
position. This can happen if, for
example, the machine door is opened
during grinding or brewing.
^ Close the appliance door. The brew
unit will position itself correctly
automatically.
65