Miele CVA 5060 Operating And Installation Instructions page 66

Problem solving guide
... the crema is not as it should be.
^ Check that the grinder setting is not
too coarse or too fine, and adjust
accordingly (see "Setting the coffee
grinder").
^ Check the temperatures the different
types of coffee have been set to. If
the temperature is too high, there will
be dark patches in the crema.
Reduce the temperature (see
"Settings: Customising your machine
- Setting the temperature").
The crema will not form correctly if stale
coffee or an unsuitable coffee blend is
used or if the central spout is set too
high.
... the cap for the central spout
connector is missing (see "Guide to
the machine" - "Interior view")?
^ Replace it with the cap supplied with
the appliance.
^ Lubricate the cap on the central
spout connector with the silicone
grease supplied.
66
... the message "Push water
container in as far as it will go"
appears.
Water has not been taken in.
^ The water container is not correctly
positioned inside the machine. Take
it out and push it back into the
machine so that it clicks into position.
^ This error message also appears if
the water container was not correctly
filled for descaling. Fill the water
container up to the marker.
If this fault message still continues to
appear in the display, repeat the steps
described above. If the fault message
still appears in the display, call Miele.
... too much crema has formed and is
overflowing above the coffee spouts.
Some types of coffee will produce too
much crema if the coffee or espresso
temperature is set to maximum and the
amount of coffee to be ground is set too
high.
^ Set a lower temperature and reduce
the amount of coffee to be ground
(see: "Settings: Customising your
machine - Setting the temperature"
and "Setting the amount of coffee").
... the slide control for the grinder
setting will not move.
^ Close the machine door and
dispense a cup of espresso coffee.
The grinder setting slide control will
now move.