Miele CVA 5060 Operating And Installation Instructions page 62

Problem solving guide
... the machine does not switch on
even although the "Switch on at"
setting for the timer has been
activated.
The system lock has been activated.
^ Deactivate it. (See "Settings:
Customising your machine - Safety:
Activating the system lock").
The machine was not used after being
switched on automatically 3 times in
succession.
^ Switch the machine on and make a
drink.
... you cannot read the display.
If the machine is installed too low down,
the display can be hard to see.
^ Try to improve this by adjusting the
display contrast or brightness (see
"Settings: Customising your machine
- Setting the display").
... very little or no coffee/espresso
comes out of the central spout.
Is the cap correctly attached to the
central spout connector (see "Guide to
the machine" - "Interior view")?
^ Lubricate the cap on the central
spout connector with the silicone
grease supplied.
62
... milk froth or milk is not flowing
freely or not at all out of the central
spout.
The spout is clogged up.
^ Clean the central spout (taking
special care to clean the rubber
stoppers thoroughly) and the milk
pipework as described in "Cleaning
and care".
... the consistency of the milk froth is
unsatisfactory.
The bypass tube is blocked.
^ Clean the bypass tube (see
"Cleaning and care" - "The central
spout"). You can loosen possible
blockages in the bypass tube by
kneading it with your fingers or
blowing air through it.
Do not use a pin or other sharp
object as these will damage
components.
The bypass tube is faulty.
^ Remove the bypass tube and replace
it with the part supplied.
... a message appears in the display
reminding you to fill or replace the
milk flask even though it is full and
positioned correctly.
^ Clean the flask thoroughly, paying
particular attention to the area around
the handle and the neck (see
"Cleaning and care - Stainless steel
milk flask").
Any soiling in these areas can
prevent the sensors for the milk flask
from working properly.