Operating Adjustments; Dmx Mode & Dmx Mode Selection; Master/Slave Mode; Sound Active Mode - Blizzard Lighting the puck User Manual

4. OPERATING ADJUSTMENTS

NOTE: After making any adjustment, hold the <MENU> button for approximately 3
seconds, otherwise the fixture will return to the correct mode after approximately 10
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
readout. Push the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between 1 and 512. Press <ENTER> again to confirm.
2.) To change between DMX channel modes, select
<ENTER>. Select either
to confirm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX connector on
the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must be the
first unit. Finally, chain the units together using DMX cable.
Master
3.) Set the fixture to slave run in slave mode by using the <UP>/<DOWN> keys to
reach either
(functions as complimentary to the master fixture).
Slave 1
Slave 2
NOTE: Fixtures in slave mode will display "
the fixture to master mode to use it as a standalone fixture.
4.) On the master fixture, use the <UP>/<DOWN> keys to reach SHND, which allows
you to select other functions:
Sound active
Auto mode
Color preset
Color strobe
Color fade
NOTE: Speed 1 = Fastest (Approx. 1.5 sec. per color), Speed 8 = Slowest (Approx.
per color).
Puck Couch Potato RGBAW Manual Rev. A
3Ch 5Ch
,
SLNd
SLV1
(which functions the same as the master fixture) or choose
SLNd
then
SLNd
then
SoUn
S1
=
S2
=
S3
=
CoLo
CoLo
StCo
FAdE
Page 14
seconds.
ChNd
2Ch
1
, then press <ENTER> again
or
NASt
then
SLU1
to confirm.
SLU2
to confirm.
STBY
" (Standby). This is NORMAL. Return
S1 - S3,
then
Sound Active + Strobe
Sound Active - Color Snap
Sound Active + Fade
Auto
then
Co 1 - Co 31
then
0-255
then (Slowest <---> Fastest)
Co 1 - Co 31
then
SPO1 - SP08
then
Addr
on the LED
, then press
to confirm.
<ENTER>.
then <ENTER> to confirm.
, <ENTER>
, <ENTER>
(Slowest <---> Fastest)
Copyright (c) 2012 Blizzard Lighting, LLC
SLV2
2 min.