Mgr4451Ad*, Mgr4452Ad*, Pgr4420Ld - Maytag AGR4400ADW Service Manual

Conversion Instructions
MGR4451AD*, MGR4452AD*, PGR4420LD*, CGR1425AD*, CGR1415AD*,
CGR1110AD*, CP31600AD*)
Orifice Conversion
To convert the unit to either natural gas or LP gas will require the exchange of orifice hoods.
Oven Burner Conversion
Remove all oven racks.
1. Bake Burner
a. Remove oven bottom (figure 2).
CLIP
FIGURE 2
b. Remove screw from the front of the bake burner.
c. Remove the bake burner from the orifice fitting.
CAUTION: The igniter is fragile. Take care not to
damage it.
d. Gently lay the bake burner in the bottom of the
range.
e. Remove the bake orifice hood with a ½² (12.7 mm)
socket wrench counter-clockwise.
f. Place the black-colored orifice stamped .0512 for LP
(.0810 for natural) on the fitting turning it clockwise
by hand approximately one turn. Tighten the orifice
hood with a ½² (12.7 mm) socket wrench clockwise
approximately 2½ turns.
g. Replace the bake burner.
h. Replace the oven bottom.
©2004 Maytag Services
(Models AGR4400AD*, AGR4412AD*,
IMPORTANT:
Save all parts removed in conversion.
16023522
Surface Burner Conversion
1. Remove all grates.
2. Mark ignitor location on the main top with a pencil. This
mark on the main top is used as a reference point
when replacing the burner assembly to ensure that the
burner is tightened to its original position.
3. Place burner wrench (part no. 8312D075-60, available
from the dealer or authorized service agency) over the
surface burner assembly with the ignitor positioned
inside the gap in the wrench ring (figure 3). This
prevents the ignitor from being damaged when the
wrench grips the burner assembly. Rotate the burner
assembly approximately one-eighth turn
counter-clockwise and lift from the main top.
4. Remove the surface burner orifice hood with a ½² (12.7
mm) socket wrench counter-clockwise.
IMPORTANT: Save all parts removed in conversion.
2
(Sealed Burner)
FIGURE 3
C–13