Models Cp31200Ad*, Cg31200Ad - Maytag AGR4400ADW Service Manual

Conversion Instructions
*$6 &219(56,21
d‚‹‚~‰
All ranges and cooktops are equipped with double coaxial
(universal) orifices and with a convertible appliance
pressure regulator. The unit model number plate states
which gas it was adjusted for at the factory. To convert the
unit to either Natural gas or LP gas will require adjustment
of the orifice hoods, air shutters on the burners and
adjustment of the appliance pressure regulator converter
cap.
Inlet pressure to the appliance pressure regulator should
be as follows for both operation and checking of appliance
pressure regulator setting:
fkibq mobpprob fk
fk`ebp lc t^qbo `lirjk
Minimum
Maximum
cfdrob NO
C–2

(Models CP31200AD*, CG31200AD*)

^‰†~‹€‚ m‚’‚ o‚„’‰~‘Œ `Œ‹“‚†Œ‹
The unit appliance pressure regulator must be set to
match the type gas supply used. If converting from natural
gas to LP gas, the appliance pressure regulator must be
converted to regulate LP gas. If converting from LP gas to
natural gas, the appliance pressure regulator must be
converted to regulate natural gas.
To convert the appliance pressure regulator from one gas
to another, do either (1), (2) or (3) below: Your unit will be
equipped with one of the three appliance pressure
regulator types shown below.
1. Remove the cap, push down and turn
k^qro^i im
d^p d^p
5 11
14 14
2. Remove plastic dust cover from cap nut on top of
3. Remove cap and forcibly snap out plastic plunger from
cfdrob NP
-10-
16023522
counter-clockwise. Turn the cap over and reinstall
(figure 12).
klqbW The gas type you are converting to must be
visible on the top of the installed appliance pressure
regulator cap.
appliance pressure regulator. Remove cap nut from
appliance pressure regulator (plastic dust cover comes
off with nut). "IMPORTANT" remove plastic dust cover
from cap nut and reinstall on opposite side of cap nut.
Reinstall cap nut to appliance pressure regulator and
replace dust cover. ¥`^rqflk³ be sure marking for
the type of gas to which appliance pressure regulator
has just been converted is visible in top of cap nut
before replacing plastic dust cover. (See figure 13).
bottom of cap. Turn plunger over and forcibly snap
back in original location (figure 14).
klqbW Plunger jrpq snap into position; the gas type
you are converting to must be visible on lower side of
plunger.
cfdrob NQ
©2004 Maytag Services