Listening To Radio - Jensen JiMS-75i User Manual

Docking digital clock radio for ipod and iphone

Hide thumbs

Table Of Contents

Table of Contents

1. Press the POWER

2. Tap the SOURCE button to select Radio mode, the radio icon

display.

3. To manually tune the radio station, tap the

manual tuning method to tune to weaker stations that are bypassed during

Automatic Tuning.

4. To automatically tune to the next radio station with the strongest signal, press and

hold the

begins to scan and then release the button. The tuner will stop scanning when it

receives the next strongest station signal.

5. Adjust the volume control to the desired volume level.

6. If no buttons are pressed for 5 seconds in radio mode, the display will change to

show current time. You can tap the DISPLAY button to check the radio station you

are listening to if necessary.

7. To turn off the unit , press and hold the POWER

HINTS FOR BEST RECEPTION:

The receiver has a build-in FM wire antenna hanging from the back of the cabinet.

This wire should be totally unwrapped and fully extended for the best reception.

NOTE: Automatic tuning depends on the signal strength of the broadcasting station,

so weak stations may be skipped. You can manually tune to find the weak

stations if a station gets skipped. With strong signals, the tuner may stop

before it reaches the actual broadcast frequency, so you may need to

manually tune for the best reception.

PRESET RADIO STATIONS

This unit has 10 preset memories for the FM radio.

1. Press the

button to turn on the unit.

2. Tap the SOURCE button to select Radio mode.

3. Tune to the desired radio station either by "manually" or "automatically" tuning

method.

4. Press and hold the TIME SET/MEMORY button to enable the program function and

the preset channel number "P01" indicator will show on the LCD and flashing for 5

seconds.

5. Tap the

6. Press the TIME SET/MEMORY button to confirm the setting.

7. Repeat above steps 3-6 to store other stations.

RECALLING PRESET MEMORY CHANNELS

In radio mode, recall the pre-set channels by pressing the MEM+ button on main unit

repeatedly.