Listening To The Radio; Bluetooth Operation - Jensen JWM-160 User Manual

Water resistant am/fm bluetooth shower clock radio with digital tuning

Hide thumbs

Table Of Contents

Table of Contents

Tap the

/SLEEP button (#1) to turn on the JWM-160.

Tap the BAND/BT button (#2) to select FM or AM mode, the radio frequency will show on

LCD Display (#11).

Press and hold the

available station. If the reception is poor, try Manual Tuning to fine-tune the station.

Press the

frequency band.

Adjust the VOLume + button (#9) or VOLume – button (#8) to the desired volume level.

If no button is pressed for 5 seconds in radio mode, the display will change to show

current time. You can tap the

frequency.

Tape the

/SLEEP button (#1) to turn the unit into Standby mode after listening.

TIPS FOR BEST RADIO RECEPTION:

The AM and FM antenna are located inside the cabinet of the unit. If reception is weak,

change the position of the unit until the internal antenna picks up the strongest signal.

Setting the Radio Station Presets

The JWM-160 allows you to store up to 10 FM stations and 10 AM stations for easy recall at

any time.

1. Tap the

/SLEEP button (#1) to turn on the JWM-160.

2. Tap the BAND/BT button (#2) to select FM or AM mode, the radio frequency will show on

LCD Display (#11)..

3. Tune to the radio station you want to store in memory.

4. Press and hold the TIME SET/MEM button (#3). The preset channel number "P01" will be

flashing on

display.

5. Tap the

button (#5) or

6. Tap the TIME SET/MEM button (#3) to confirm.

7. To store up to 10 station presets, repeat steps 3 to 6 above.

RECALLING PRESET MEMORY CHANNELS

To recall a preset station,

1. In radio mode, tap the PRESET TIME SET/MEM button (#3), the preset number will

appear on display.

2. Tap the TIME SET/MEM button (#3) repeatedly to select the preset channel.