Setting The Clock; Listening To The Radio; Radio Tuning - Jensen JCR-175A User Manual

SETTING THE CLOCK

When you connect the radio to an AC outlet for the first time the clock display will
begin flashing "12:00". The flashing will stop when you set the time.
1. If clock display is not flashing, press and hold the
mode, display will start flashing to enter clock set mode. Tap the HOUR button
repeatedly to set the correct hour. Press and hold the button for fast advance
setting.
2. After hour set, tap the MINUTE button repeatedly to set the correct minute.
Press and hold the button for fast advance setting.

3. Tap the button to finish clock setting. If you do not tap the
10 seconds, the unit will automatically save the setting and exit the time set
mode.
Note:
There is a PM INDICATOR located on the left-hand side top corner of the
clock display. Be sure to observe the PM indicator when setting the time to make
sure the time is set correctly for AM or PM. If the PM indicator is 'On', the
time displayed is "PM". If the PM indicator is Off, the time displayed is "AM ".

RADIO TUNING

1. Tap the RADIO ON button to turn on the unit.
2. Tap the MODE button to select AM or FM radio. Radio frequency will show in
display.
3. To manually tune to a desired station, repeatedly tap the TUNING +/- buttons.
4. To automatically search for stations with strong signals, press and hold either
the TUNING + or TUNING – button until the frequency digits on display begins
to scan then release the button, the tuner will stop on the first strong station it
finds.
5. Press the VOLUME + and VOLUME - button to the desired listening level.
6. When you have finished listening, press the
Notes:

Manual tune to select weaker stations that might be skipped during
automatic tuning.

If the automatic tuning does not stop on the exact frequency of the station,
OPERATING INSTRUCTIONS

LISTENING TO THE RADIO

button to turn the radio off.
E‐7

button in unit standby

button within