How To Wire Your Ceiling Fan - Emerson CURVA SKY CF144BS00 Owner's Manual

BP7407-1 44" & 52" Curva Sky
2. Pull the electrical supply black, white
and ground wires through the center
opening of the ceiling mounting plate
before securing the plate to the outlet
box (Figure 6).
3. Position the ceiling mounting plate onto
the outlet box and secure using the two
outlet box screws, supplied with outlet
box (Figure 6).
OUTLET BOX
SCREWS (2)
Figure 6
4. Slide the ceiling trim ring over the fan
motor assembly and let it rest on the
motor assembly (Figure 7).
FAN MOTOR
ASSEMBLY
CEILING
TRIM
RING
Figure 7
5. Place the motor assembly onto the
ceiling mounting plate hook during
wiring fan motor assembly to outlet box
(Figure 8).
CEILING
MOUNTING
PLATE
FAN MOTOR
ASSEMBLY
Figure 8
8/31/10 4:10 PM Page 7
Your Ceiling Fan
If you feel that you do not have enough
electrical
experience, have your fan installed by a
licensed electrician.
OUTLET
Turning off wall switch is not sufficient. To
BOX
avoid possible electrical shock, be sure
electricity is turned off at the main fuse
box before wiring. All wiring must be in
CEILING
MOUNTING accordance with National and Local
PLATE
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
CEILING
CAUTION: To reduce the risk of electrical
MOUNTING
shock, disconnect the electrical supply
PLATE HOOK
circuit before installing the fan, light kit
or receiver.
NOTE: Make all wiring connections
using wire connectors (supplied). Make
sure that all connections are tight,
including ground, and that no bare wire
is visible at the wire connectors, except
for the ground wire.
1. Position the receiver into the fan motor
housing as shown in Figure 9.
2. Refer to Figures 9 and 10 to connect
the receiver wires to the supply wires
and the fan motor wires using the wire
connectors supplied with the fan as
follows:
a. Securely connect the green grounding
wire from the ceiling mounting plate
and green grounding wire from fan
body to the supply green grounding
conductor (this may be a bare wire or a
wire with green insulation).
b. Securely connect the supply white
(neutral) wire to the receiver white
(AC IN N)/(TO MOTOR N) wire and
white (neutral) fan wire.
HOOK
c. Securely connect the supply black wire
to the receiver black/white (AC IN L)
wire.
d. Securely connect the fan motor black
wire to the receiver black (TO MOTOR
L) wire.
e. Securely connect the fan motor blue
wire to the receiver blue (FOR
BOTTOM LIGHT) wire.
7
How to Wire
wiring knowledge
WARNING
!
UL Model No.: CF144 & CF152
or