Emerson CURVA SKY CF144BS00 Owner's Manual page 13

BP7407-1 44" & 52" Curva Sky
Light Kit Circuit Breaker
- Canada Only
In accordance with Federal Law, this
ceiling fan is equipped with a light kit
circuit breaker. Using halogen light bulbs
with greater than 50 watts rating will cause
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR
!
CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN.
TROUBLE
1. Fan will not
start.
2. Fan sounds
noisy.
3. Fan wobbles
excessively.
4. Both lamps will
not illuminate.
8/31/10 4:10 PM
the breaker to activate. If this occurs, shut
off the electricity to the ceiling fan and
check that the lamps are each 50W
maximum. The light kit circuit breaker will
automatically reset when the electricity is
turned off and then back on.
Ceiling Fan Trouble Shooting
PROBABLE CAUSE
1. Fuse or circuit breaker
blown.
2. Loose power line
connections to the fan.
3. Fan/Light remote control is OFF.
1. Blades not attached to fan.
2. Screws securing fan blades
to motor are loose.
1. Screws securing fan blades
to motor are loose.
2. Fan blades are not seated
properly.
3. Fan blades out of balance.
1. Loose electrical connectors.
2. Remote control battery is weak. 2. Replace the AAA remote
3. The lamps are burnt out.
4. Lamps turn on and then turn off. 4. The built in circuit breaker is
13
Page 13
SUGGESTED REMEDY
1. Check main and branch
circuit fuses or circuit breakers.
WARNING: Make sure
!
main power is turned off.
2. Check line power connections
to fan.
3. Turn ON Fan/Light remote control.
1. Attach blades to fan before
operating.
2. Check to make sure the screws
which attach the blades to the
motor are tight.
WARNING: Make sure main
!
power is turned off.
1. Check to be sure screws which
attach the fan blade to the
motor are tight.
2. Check to be sure that the
screws securing the fan
blades seat firmly.
3. Interchanging an adjacent (side
by-side) blade pair can
redistribute the weight and result
in smoother operation.
Or use supplied balancing kit to
balance blades.
1. Shut off the branch circuit
electricity at the fuse box or
breaker panel and check the
receiver electrical connectors
for proper installation.
batteries.
3. Turn the electricity off and
replace the lamps with new
50W max. lamps.
tripping, check that the lamps
are each 50W maximum.
CAUTION: Turn the lights off
before touching halogen lamps,
they are very hot and can burn
your fingers.
UL Model No.: CF144 & CF152