Operation Of Wireless Remote Control; Sleep Button; Fan Button; Clock Button - ComfortStar CARAT18-CD Service Manual

Operation of wireless remote control

Note: Be sure that there are no obstructions between receiver and remote controller;
Don't drop or throw the remote control; Don't let any liquid in the remote control and
put the remote control directly under the sunlight or any place where is very hot.
Signal transmitter
Remote control
ON/OFF button
● Press this button, the unit will be turned on,
press it once more, the unit will be turned
off. When turning on or turning off the unit,
the Timer, Sleep function will be canceled,
but the presetting time is still remained.
MODE
MODE button
●
Press this button, Auto, Cool,
Heat mode can be selected circularly.
Auto mode is default while power on.
Under Auto mode,the temperature will not
be displayed; Under Heat mode, the
initial value is 28
modes, the initial value is 25
AUTO
COOL
DRY
FAN
HEAT
(Only for cooling and heating unit.)
Dry, Fan,
o
F) ;Under other
( 82
o
( 77 F) .
SLEEP

SLEEP button

●
Press this button, Sleep On and Sleep
Off can be selected. After powered on,
Sleep Off is defaulted. After the unit is
turned off, the Sleep function is canceled.
After Sleep function set up, the signal of
Sleep will display. In this mode, the time
oftimer can be adjusted. Under Fan and
Automodes, this function is not available.
FAN

FAN button

●
Press this button, Auto, Low, Middle, High
speed can be circularly selected. After
powered on,Auto fan speed is default.
Under Dehumidify mode, Low fan speed
only can be set up.
AUTO
Low fan
High fan
CLOCK

CLOCK button

●
Press this button, the clock can be set up,
signal blink and display.Within 5
seconds, the value can be adjusted by
pressing + or - button, if continuously
press this button for 2
in every 0.5 seconds, the value on ten place
of Minute will be increased 1. During blinking,
repress the Clock button, signal will be
constantly displayed and it denotes the
setting succeeded. After powered on, 12:00
is defaulted to display and signal will
be displayed. If there is signal be
displayed that denotes the current time
value is Clock value, otherwise is Timer
value.
LIGHT
LIGHT button
●
Press this button at unit On or Off status,
Light On and Light Off can be set up.
After powered on, Light On is defaulted.
Middle fan
seconds above,