Timer On Button; Timer Off Button; Health Button; I Feel Button - ComfortStar CARAT18-CD Service Manual

Notice: This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model dosen't have, if press the
corresponding button on the remote controller that the unit will not receive this signal
and will keep the original running status.
Remote control
SWING UP and DOWN BUTTON
Press this button, to set up swing angle,
which circularly changes as below:
OFF
This is an universal use remote controller.
If it received the following three kinds of
status, the swing signal is:
When the guide louver start to swing up and
down, if turn off the Swing, the air guide louver
will stop at current position.
which indicates the guide louver swings up
and down between that all five positions.
AIR BUTTON
● There is no this function for this unit. If
press this key, the main unit will click,
but it also runs under original status.
TIMER ON

TIMER ON BUTTON

Timer On setting: Signal "ON" will blink
and display, signal
numerical section will become the timer
on setting status. During 5 seconds blink,
by pressing
time value of numerical section, every
press of that button, the value will be
increased or decreased 1 minute. Hold
pressing or
it quickly change, the way of change is:
During the initial 2.5 seconds, ten numbers
change in the one place of minute, then
the one place is constant, ten numbers
change in the tens place of minute at 2.5
seconds speed and carry. During 5s blink,
press the Timer On button, the timer on
settingsucceeds. The Timer On has been
set up, repress the timer on button, the
Timer On will be canceled. Before setting
the Timer, please adjust the Clock to the
current actual time.
TIMER OFF

TIMER OFF BUTTON

● Once press this key to enter into
TIMER OFF setup, in which case
the TIMER OFF icon will blink.
The method of setting is the same
as for TIMER ON.

HEALTH BUTTON

● Press this button, can set up Health function
on or off. After unit is turned on, Health
function ON is defaulted.
Some models don't have this function.
I FEEL

I FEEL BUTTON

● Press this button, to turn on the I FEEL
function. When operating other function
and after signal was sent out, every 200ms
later, the I FEEL information will be sent
out. After I FEEL function turned on, in
every 10mins, the remote controller will
send the temperature information to main
controller. If repress this button, the I
FEEL function will be turned off.
will conceal, the
or button to adjust the
button, 2 seconds later,