Engineering Of Electrical Wiring; Test Operation - ComfortStar CZP09CD Service Manual

Be sure not bind the insulation material

over-tight, it may extrude out the air in the
material to cause bad insulation and cause
easy aging of the material.
13.8.2 Insulation of drainage pipe
1 Operational procedure of refrigerant
pipe insulation
Select the suitable pipe → insulation (except
joint section) → piping layout and connection→
drainage test→ insulate the joint parts
2 Purpose of drainage pipe insulation
The temperature of condensate drainage water
is very low. If insulation is not enough, it shall
form dew and cause leakage to damage the
house decoration.
3 Insulation material
drainage pipe
The insulation material should be flame

retardant material, the flame retardancy of
the material should be selected according
to the local law.
Thickness of insulation layer is usually

above 10mm.
Use specific glue to paste the seam of

insulation material, and then bind with
adhesive tape. The width of tape shall not
be less than 5cm. Make sure it is firm and
avoid dew.
4 Installation
insulation construction
The single pipe should be insulated before

connecting to another pipe, the joint part
should be insulated after the drainage test.
There should be no insulation gap between

the insulation material.

14.9 Engineering of electrical wiring

1 Highlights
installation
All field wiring construction should be

finished by qualified electrician.
Air conditioning equipment should be

grounded according to the local electrical
regulations.
selection
and highlights
of electrical wiring
Current leakage protection switch should

be installed.
Do not connect the power wire to the

terminal of signal wire.
When power wire is parallel with signal wire,

put wires to their own wire tube and remain
at least 300mm gap.
According to table in indoor part named

"the specification of the power" to choose
the wiring, make sure the selected wiring
not small than the date showing in the
table.
Select different colors for different wire

according to relevant regulations.
Do not use metal wire tube at the place with

acid or alkali corrosion, adopt plastic wire
tube to replace it.
There must be not wire connect joint in the

wire tube If joint is a must, set a connection
box at the place.
for
The wiring with different voltage should not

be in one wire tube.
Ensure that the color of the wires of outdoor

and the terminal No. are same as those of
indoor unit respectively.

14.10 Test operation

1 The test operation must be carried out
after the entire installation has been
completed.
2 Please confirm the following points
before the test operation.
The indoor unit and outdoor unit are

of
installed properly.
Tubing and wiring are correctly completed.

The

leakage-checked.
The drainage is unimpeded.

The ground wiring is connected correctly.

The length of the tubing and the added

stow capacity of the refrigerant have been
recorded.
The power voltage fits the rated voltage of

the air conditioner.
There is no obstacle at the outlet and inlet

of the outdoor and indoor units.
The gas-side and liquid-side stop values

are both opened.
The air conditioner is pre-heated by turning

on the power.
3 Test operation
169
refrigerant pipe system is