Table of Contents
Advertisement
About lock
Press +and - buttons simultaneously to lock or unlock the keyboard. If the remote controller
is locked, the icon
flicker for three times. If the keyboard is unlocked, the mark will disappear.
About swing up and down
1. Press swing up and down button continuously more than 2s,the main unit will swing back
and forth from up to down, and then loosen the button, the unit will stop swinging and present
position of guide louver will be kept immediately.
2. Under swing up and down mode, when the status is switched from off to
button again 2s later,
within 2s,the change of swing status will also depend on the circulation sequence stated above.
About switch between Fahrenheit and Centigrade
Under status of unit off, press MODE and - buttons simultaneously to switch
About new function of defrosting
It indicates: after starting this function by remote controller and the unit has been under
defrost status, If turn off the unit by remote controller, the unit will not stop defrosting until
it is finished; if change setting mode by remote controller, the function ,which is set last
time, won't be carried out until defrosting finished.
Operation of this function on or off: If remote controller is under off status, press mode button
a
n
d
b
o l
w
b
t u
o t
n
s
m i
u
a t l
defrost mode, dual eight position on remote controller will display H1.If switch to heat mode,
the position will display H1, which flickers for 5s, in which case, press +/- button, H1 will
disappear and setting temp. be displayed.
After remote controller is powered on, the new defrost function will be defaulted to be closed.
1.
Slightly to press the place with
remote control. (As show in fig.1)
2.
Take out the old batteries. (As show in fig.1)
3.
Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in fig.2)
4.
Attach the back cover of wireless remote control. (As show in fig.2)
NOTE:
●
When changing the batteries, do not use the old or different batteries,
otherwise, it can cause the malfunction of the wireless remote control.
●
If the wireless remote control will not be used for a long time, please
take them out, and don't let the leakage liquid damage the wireless
remote control.
●
The operation should be in its receiving range.
●
It should be placed at where is 1m away from the TV set or stereo sound sets.
●
If the wireless remote control can not operate normally, please take them out,
after 30s later and reinsert, if they cannot normally run, please change them.
will be displayed on it, in which case, press any button, the mark will
status will switch to off status directly; if press this button again
n
e
o
s u
y l
n i
o
d r
r e
o t
e
t n
r e
Changing batteries and notices
, along the arrowhead direction to push the back cover of wireless
r o
a c
c n
l e
h t
s i
n
e
w
u f
c n
, if press this
o i t
. n
f I
h t
e
u
t i n
s i
u
n
d
r e
Fig.1
Sketch map for
changing batteries
Fig.2
Hide quick links:
Advertisement
Table of Contents
