The instructions before use Be sure to cut off the p- ower supple when not us- ing the air conditioner for a long time.
Page 7
The power cirds of this air con- ditioner adopt Y-type connecti- on,please don t cut off or da- magethe power cords and con- trol.If the supply cord is its ser- vice agent or similarly qualified persons inorder to avoid a haz- ard.
Page 8
Name and Function-Remote conteol Note: Be sure that there is on obstruction. Don't drop or throw the remote control. Don't place the remote control in a location exposed to direct sunlight. Whe the unit is restarted after stopped,it can automatically resume its most latest running mode,and the outdoor unit starts a little bit later.
Page 9
Name and Function-Remote control(continue) Note: This type of remote control is a kind of new current.Some buttons of the control which have extra function will be described below. Liquid crystal displayer It shows all set contents. SWING Button At unit turned on, press this button once to start the SWING function, when press the button once again will stop.
How to insert batteries 1.Remove the cover from the back of the remote control. 2.Insert the two batteries(Two AAA dry-cell batteries). 3.Re-attach the cover. NOTE: Don't confuse the new and worn or different batteries. Remove batteries when not in use for a longtime. The batteries can be used for about one year.
Installtion Installtion location Indoor Unit 9. Do not use the unit in the immediate surrpundings of a laundry ,a bath ,a shower or a swimming pool. 10. The plug should be accessible after the appliance is positioned. Outdoor unit...
Page 17
Diagram of Condensate Pump (Indoor unit) ------CHH009CA-13B(I), CHH012CA-13B(I), CHH012CD-13B(I) Note: The device of condensate pump is not provided with this air conditioner unit when you purchase. If you need the device, you can buy it and install it according to...
Install the indoor unit Install the rear panel Install the piping hole Install the drainage hose Install the connection pipes Electric wiring...
Page 19
Connect the Neutr a l wir e of the power connection ca bles to the N (1) ter mina l of the ter m- ina l boa r d, connect the Signa l wir e to the “2”ter mina l, a nd connect the live wir e to the“3”ter m- ina l a nd connect the ea r thing wir e to the “...
Install the outdoor unit Install the connection pipe Electric wiring connection Signal Control Cable Power (Only for Heating and Connection Cooling Type Unit) Cable Connecting Block Coo/Heat for Outdoor Unit Model Diagram Power Connection Cable Connecting Block for Indoor Unit...
Care and maintenance Care and maintenance Clean the front panel ( When cleaning the front panel do not take it off) When the indoor unit front panel is dirty, please use the cloth which is soaked in the warm water under 40 then dry it and wipe the dirty places.
Need help?
Do you have a question about the CHH009CA-13B and is the answer not in the manual?
Questions and answers