Replacing The Fuse; Replacing A Gobo From The Rotating Gobo-Wheel - SHOWTEC Indigo 150 LED User Manual

monthly with a soft brush.
Please clean internal components once a year with a light brush and vacuum cleaner.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
so.
1. Unplug the unit from electric power source.
2. Insert a flat-head screwdriver into a slot in the fuse cover. Gently pry up the fuse cover. The fuse will
come out.
3. Remove the used fuse. If brown or unclear, it is burned out.
4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Replacing a Gobo
Gobo-wheel with rotating gobo‟s
1. Disconnect mains power supply and set the switch to OFF.
2. Make sure that the gobo you want to insert has the same size. For the right size, see below.
3. Unlock the 2 goboslots on top of the housing. Lift the small maintenance cap.
4. Turn the gobo wheel, with the gobo you want to remove, to the upside.
4. Gently lift up the gobo holder
5. Very carefully take the gobo out of the gobo holder with a pair of pliers.
6. Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the pinchcock
a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.
7. Put the gobo holder back under the pressing snap and push it back.
8. Replace the maintenance cap and fasten all screws.
Fig. 7
10º and then gently pull out the gobo from its position.
22
follow the directions below to do
Fig. 8