Adjusting The Touchpad Beeps; Adjusting The Touchpad Display Brightness; Notification By Pager; Pager Messages - GE Concord express User Manual

3. To turn Silent Arming:
2 ƒ
q
on, press +
sound while arming.
1 ƒ
q
off, press +
sound from touchpad while arming.
‚ 4 ƒ
4. Press + + to exit the programming menus.

Adjusting the Touchpad Beeps

The frequency or pitch of chime and trouble beeps from
each fixed display touchpad can be adjusted individually
to a more desirable or distinct tone.
Chime and trouble beep tones sound using the default fre-
quency during, or within 15 seconds of, any button activity
at that specific touchpad.
To change status tone pitch:
‚
1. Press and hold the
tone, then release the buttons.
1
2. Press and hold to lower the pitch or press and hold
2
to raise the pitch.
3. Release the button when the desired pitch is heard.
After about 10 seconds of no touchpad activity, the steady
tone stops sounding.
Adjusting the Touchpad Display
Brightness
You may want to change the brightness of a touchpad dis-
play based on its location in a building or room. For exam-
ple, dim the touchpad display in a bedroom or enhance a
display near a window.
Changing the touchpad display affects only the touchpad
currently being used.
To change touchpad display brightness:
1. Enter the programming menus by pressing
9
+ System Master Code.
2 2
2. Press + .
3. Select a brightness level:
0 ƒ
q
+ Off
1 ƒ
q
+ Low
2 ƒ
q
+ Medium
3 ƒ
q
+ High
‚ 4 ƒ
4. Press + + to exit the programming menus.
After dimming the display, pressing any button momen-
tarily returns the display to full brightness. After 15 sec-
onds without touchpad activity, the display returns to the
set dimmed level. If an alarm occurs while the display is
dimmed, it automatically returns to the full brightness
level and stays that way until you disarm your system.
. No system status beeps will
. System status beeps will
0
and until you hear a steady

Notification by Pager

Your system can notify up to three different pager phone
numbers to report system events. The installer can pro-
gram any pager to receive pages for one or more of the fol-
lowing groups:
‰ High Level Reports, which includes the following
reports:
– Sensor alarms
– Sensor Tamper
– Sensor Restores
– Phone test
– Receiver failure
– Receiver jam
– Touchpad tamper
‰ Low Level Reports, which includes the following
reports:
– Bypass sensors
– Sensor Low battery
– Sensor Supervisory
– Sensor Trouble
– Phone test
– Touchpad supervisory
– Touchpad low battery
– Force armed(reports when a user bypasses sensors
while arming system)
‰ Opening and Closing reports
‰ Latchkey Paging

Pager Messages

When an event is reported on a numeric pager, the follow-
ing information is included:
E v e n t c o d e
S e n s o r n u m b e r o r u s e r n u m b e r
Although all three types of information can be reported on
your pager, your pager service determines how the infor-
mation will actually appear.
Notification by Pager
– Bus failures
– No activity alarm
– Fire panic
– Police panic
– Auxiliary panic
– Duress alarm
– AC power fail
– CPU low battery
– Auto phone test
– CPU back in service
– Phone Failure
– Event buffer full
L a s t f o u r d i g i t s o f c e n t r a l
s t a t i o n a c c o u n t n u m b e r
11