Table of Contents
Advertisement
Adjusting
System Sounds
and Touchpad
Brightness
Note
If Quick Arm feature is on,
an access code is not
required. See "Quick Arm"
for more information.
Security Pro 7000
For example, if the current date is January 15, 2000, press
*
00
#
4. Press
+
+
to exit the programming menus.
Arming Your System Silently
Use the Silent Arming feature to arm your system without disturbing people throughout the
house with arming status beeps. There are two methods for implementing Silent Arming:
•
Silent on Demand. (User presses
•
Arming Always Silent (Silent Arming feature on).
Regardless of the method employed, when Silent Arming is in effect, no Exit beeps sound.
Silent Arming on Demand
5
Pressing
before arming silences arming status beeps from touchpads and interior sirens for
only the current arming period.
¾
To use Silent Arming on demand:
1. From any touchpad, press
2. Within 4 seconds enter:
Arming Always Silent
Turning this feature on in User Programming means that the status beeps that come from touch-
pads and interior speakers while arming will always be silent. You will not have to enter
before arming, as with Silent Arming on Demand.
¾
To enable Silent Arming:
1. Enter the programming menus by pressing
041
2. Press
.
3. To turn Silent Arming:
Š on, press
2
#
+
. No system status beeps will sound while arming.
Š off, press
1
#
+
. System status beeps will sound from touchpad while arming.
*
00
#
4. Press
+
+
to exit the programming menus.
Adjusting the Touchpad Beeps (Fixed Display Touchpad Only)
The frequency or pitch of chime and trouble beeps from each fixed display touchpad can be
adjusted individually to a more desirable or distinct tone.
Chime and trouble beep tones sound using the default frequency during, or within 15 seconds of
any button activity at that specific touchpad.
¾
To change status tone pitch:
*
0
1. Press and hold
+
until you hear a steady tone, then release the buttons.
1
2. Press and hold
to lower the pitch or press and hold
3. Release the button when the desired pitch is heard.
After about 15 seconds of no touchpad activity, the steady tone stops sounding.
Adjusting the System Status Voice Volume
If you have an optional speaker installed, you may want to adjust the volume at which system
status messages are announced.
¾
To change the voice volume:
1. Enter the programming menus by pressing
043
2. Press
.
1
3. Select a volume level
*
00
#
4. Press
+
+
to exit the programming menus.
5
before arming.)
5
.
2
CODE
3
CODE
+
or
+
9
+ System or Partition Master
9
+ System or Partition Master
7
–
(7 being the loudest) and press
011500
#
+
.
.
CODE
2
to raise the pitch.
CODE
#
5
.
.
17
Advertisement
Table of Contents
