Table of Contents
Advertisement
Chapter 4: E2 Controller
Factory>Group>Group Status (Screen 8) provides an overview of the current duty status for all the A/C units combined in the
group.
Display Description
Description
Running
Display indicates how many units in the group are currently operating.
Active
Display indicates how many units in the group are currently active.
Standby
Display indicates how many units in the group are currently in standby.
Assist
Display indicates how many units in the group are currently operating in the capacity assist mode.
Online
Display indicates how many units in the group are currently available to operate.
Out of Service
Display indicates how many units in the group are not available to operate.
The final step to configure a workgroup is to access the Service>Options>Group Setup screens used to configure parameters that
apply to how individual A/C units interact in the workgroup (see Section 4.6.2.7).
Display Description
Lead unit
Plan timer
pLAN present
4.6.2.7 Service>Options>Group Menu Screens
Accessed in the Service menu, the Service>Options>Group Setup screens only appear if two or more units are wired together as
a workgroup.
4.6.2.7.1 Group Setup
Page 92
Table 4-23. Factory>Group>Group Status (Screen 8) parameters.
Figure 4-90. Factory>Group>pLAN timing (Screen 9).
Table 4-24. Factory>Group>pLAN timing (Screen 9) parameters.
Description
Display indicates which unit is currently the lead.
Display indicates the time delay (in seconds) between the detection of
a communication failure and the annunciation of a Comm alarm.
Display indicates if a pLAN is detected by the controller.
Figure 4-91. Group setup screen.
724-746-5500 | blackbox.com
Variables
0 to 8
0 to 8
0 to 8
0 to 8
0 to 8
—
Variables
Default
0 to 8
0
0 to 60
30
0 = No
No
1 = Yes
Default
0
0
0
0
0
0
Advertisement
Table of Contents
Troubleshooting
