Section 2 : Installing Your Velocd Rewriter; Open The Computer And Prepare For Installation - TDK veloCD ReWRITER Installation And User Manual

INSTALLING YOUR veloCD ReWRITER
This chapter explains how to physically install your veloCD ReWRITER in your computer.
The steps are as follows:
1. Turn OFF your computer system and unplug the power cord.
2. Set the jumpers for your new veloCD ReWRITER.
3. Mount the veloCD ReWRITER into an available drive bay inside the computer system.
4. Make all necessary cabling connections: IDE cable, power cable, and audio cable.
5. Turn your computer system ON.
The following pages give more details for this procedure.
TO OPEN THE COMPUTER:
1. Before proceeding, make sure the power to your computer and any external peripherals are OFF
and your computer is UNPLUGGED from its power source.
2. Remove your computer's cover, following the directions provided by your computer's manufacturer.
Typically, this involves loosening or removing several screws on the back panel of your computer
and sliding off the cover. See Figure 3 for details.
Figure 3: Removing a Typical Computer's Cover
2
SECTION

SECTION 2 : Installing Your veloCD ReWRITER

5