Handling Cd Media; Cleaning Discs; Playing Audio Cds - TDK veloCD ReWRITER Installation And User Manual

Internal atapi-ide cd rewriter drive
Table of Contents

Advertisement

HINT: Keep your frequently used discs in storage cases at
all times to prevent them from becoming dirty or damaged.
NOTE: The volume control on the front panel of your
drive adjusts only the sound level of the headphone
jack. It has no impact on the volume level of the rear
panel audio outputs. TDK CD Blender software can
control volume level of the signal from the rear panel
audio outputs.
18
veloCD ReWRITER : User's Manual

Handling CD Media

Take care when handling blank CD-R and CD-RW media. Dust, scratches, and fingerprints on the
data side of the disc can cause write errors during recording. When picking up or holding blank media
you can either place your fingers on the outer edge of the disc, or one finger through the center hole
and one finger along the outer edge. Once you have finished creating a disc, label it by writing on the
top using permanent ink.

Cleaning Discs

For proper read and write performance, your CD-R, CD-RW, and CD-ROM discs must be clean.
Trying to record on a dirty disc may result in a failed session and ruin the disc.
To clean the disc, wipe it using a clean, soft cotton cloth to remove surface dirt such as fingerprints.
Use a straight-line motion, wiping from the center out. Do not wipe the disc in a circular motion.
Figure 13: Wipe the Disc from the Center Outward

PLAYING AUDIO CDs

To listen to an audio CD, plug a pair of stereo headphones or self-powered speakers into the
headphone jack on the drive's front panel, as shown in Figure 14.
Figure 14: Connections for Playing Audio Using the Headphone Jack
Stereo mini-plug
(to headphone jack)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the veloCD ReWRITER and is the answer not in the manual?

Related Products for TDK veloCD ReWRITER

This manual is also suitable for:

Velocd

Table of Contents