Table of Contents
Advertisement
Diskette drive (external)
The diskette drive is not recognized
•
You see an "Access Denied" or "Write protect" error message
•
•
•
•
You see a "Disk is full" error message
•
•
•
You see a "Non-system disk," "NTLDR is missing," or "Disk
error" error message
•
•
The diskette drive status indicator is lit continuously
•
Display
The screen is too dark
•
The screen resolution is not correct
•
96
CHAPTER 9: Troubleshooting
Shut down and restart your convertible notebook.
Move the write-protection tab in the upper-right corner
of the diskette down (unprotected).
The diskette may be full. Delete unnecessary files on the
diskette and try again.
Not all diskettes are IBM-compatible. Make sure that the
diskette you are using is IBM-compatible.
Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
Delete unnecessary files on the diskette.
Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
Run Error checking on the diskette. If errors are detected
and corrected, try using the diskette again.
Eject the diskette from the diskette drive, then press
E
.
NTER
Make sure that the diskette you are using is
IBM-compatible.
Remove the diskette from the drive. If the indicator stays
on, try restarting your convertible notebook.
Adjust the brightness using the system keys or Windows
Mobility Center. For more information about adjusting
the brightness, see
Change the screen resolution from the Display Settings
dialog box.
"Adjusting brightness" on page
39.
Advertisement
Table of Contents
Troubleshooting
