Help Menu; Service Menu - Paradise Datacom P300 Series Installation & Operating Handbook

6.19

HELP MENU

Action Menu
The options on this menu are as follows:
This provides a short route to switch off the Tx carrier in an emergency. It
is operational even when under Remote M&C and normal access to the carrier
on/off control is disabled (along with most other local control). A single further
submenu provides the `are you sure` type check, pressing 1 at this next menu
will switch off the Tx carrier. Note the key sequence to switch off the carrier
is therefore `911` from the main menu. So the key sequence Main, 9,1,1 will
kill the Tx carrier whatever screen was left active on the display.
NOTE: This is an OFF only selection, to switch the carrier on again you must
use the normal sequence, Change, Tx, Mod, Carrier, On. Although `911` is
available in both local and remote M&C, access to the normal carrier on/off
control is only available under local control. So if a unit is set for remote control,
either the carrier must be switched on by remote M&C, or the unit must be
returned to local control.
A short and simple guide to menu operation
A sequential glossary of some of the standard telecomms abbreviations used
during menu operation.
6.20

SERVICE MENU

The service menu is available by selecting 0 from the main menu. It provides options not normally
required when configuring the Modem.
Service Menu
P300H P300 Series Modem Installation and Operating Handbook
Help: 1:Emergency Tx Carrier Off
2:Menu operation 3:Glossary
Service: 1:User Parameters
2:Factory parameters
Page 133