Help Menu; Service Menu - Paradise Datacom P300-VSAT Installation & Operating Handbook

6.18

HELP MENU

The options on this menu are as follows:
EMERGENCY TX
CARRIER OFF
MENU
OPERATION
GLOSSARY
6.19

SERVICE MENU

The service menu is available by selecting 0 from the main menu. It provides options not normally required
when configuring the Modem.
P300H
Help: 1:Emergency Tx Carrier Off
2:Menu operation 3:Glossary
Action Menu
This provides a short route to switch off the Tx carrier in an emergency. It
is operational even when under Remote M&C and normal access to the carrier
on/off control is disabled (along with most other local control). A single further
submenu provides the `are you sure` type check, pressing 1 at this next menu
will switch off the Tx carrier. Note the key sequence to switch off the carrier
is therefore `911` from the main menu. So the key sequence Main, 9,1,1 will
kill the Tx carrier whatever screen was left active on the display.
NOTE: This is an OFF only selection, to switch the carrier on again you must use
the normal sequence, Change, Tx, Mod, Carrier, On. Although `911` is available
in both local and remote M&C, access to the normal carrier on/off control is only
available under local control. So if a unit is set for remote control, either the
carrier must be switched on by remote M&C, or the unit must be returned to local
control.
A short and simple guide to menu operation
A sequential glossary of some of the standard telecomms abbreviations used
during menu operation.
Service: 1:User Parameters
2:Factory parameters
Service Menu
P300 Modem Installation and Operating Handbook Page 121