Menu Structure Diagrams - Paradise Datacom P300 Series Installation & Operating Handbook

When the configuration is complete, select from the main menu, check the LED status
indicators, and read the message on the LCD . The messages are carefully worded to convey as much
information as possible about any faults.
If you have configured the unit, but it will not operate as expected, try , this takes
approximately 10 seconds to run and checks the configuration for unusual settings (eg IBS with 7/8 rate
FEC). If anything is found a warning is displayed and can be masked by pressing YES. These are only
warnings, and after you mask each displayed warning you may continue to operate in that mode if
required.
Use the screens to display the summarised configuration.
Then, if need be, read the rest of this handbook. If that fails, when you are sure you have the unit
c onfigured correctly and you have checked the status on the LCD, call us for technical support. W e will
do our best to remotely diagnose the problem.

6.2 MENU STRUCTURE DIAGRAMS

The full modem menu structure is presented on the following pages. In order to not over-complicate the
menu screens for modems, which do not have the full feature set, some menu options only display if
features are fitted and/or active.
Items in [Square Braces] are relevant only when the modem is configured in certain modes and are not
displayed unless the modem is suitably configured. For example menu options relating to certain
features of IBS or IDR framing only display if the Tx or Rx Service is set for IBS or IDR.
Items displayed with a -Option suffix such as [AGC OUTPUT]-Option: Monitor/AGC only appear on
the menu's when the relevant feature is available on that modem. This may be a feature controlled by a
front panel entered Feature Code or a feature requiring a hardware option (as per this example).
Some items require not only the feature to be available in the modem, but also the feature to be currently
active before they are displayed. For example the option to raise a deferred alarm if the distant Eb/No
falls below a certain level (shown on the diagrams as [DISTANT Eb/No]-Option: AUPC) requires the
AUPC feature to be available and switched on before the menu option is shown.
P300H P300 Series Modem Installation and Operating Handbook Page 44