Setup - Initial Configuration Menu; Change Menu - Paradise Datacom P300 Series Installation & Operating Handbook

6.4 SETUP - INITIAL CONFIGURATION MENU

When delivered, or if the non-volatile memory should ever be cleared, the unit must be completely
configured using the
the procedure described below to ensure all parameters are set. Only when '
' has been performed once can
operation is not selected until all critical parameters are specified.
Other options on the
: Which allow the setup to be checked, and looks for unusual combinations of
configuration parameters (eg IBS with rate 7/8 FEC coding, multiple scramblers
selected). Check does not prevent operation with any configuration; it is simply
a convenience for the operator if there are configuration difficulties. The Setup
Check takes several seconds to run and displays a message when the process
is complete.
memories of the Modem. The current configuration can be stored, another
recalled, or an old stored configuration deleted. This provides a fast method of
switching between multiple configurations when required.

6.5 CHANGE MENU

It is under the Change menu that individual parameters may be varied after an initial
has been performed. If the unit is operating under Remote M&C, the options on the change
screen are limited to only the remote M&C configuration & the time/date:
4:Rem M&C 5:User-Opt 6:Time/Date 7:BUC/LNB
Change Menu (local control)
Normal Change Screen (local control):
(Option 7: BUC/LNB only on P310 L-Band modems).
Change Screen (Remote M&C):
Change Menu (remote M&C)
Each of these options will be described in the following sections:
P300H P300 Series Modem Installation and Operating Handbook
option. This takes the operator through all the sections of
be selected from the main menu. This ensures
Setup: 1:Initial Config 2:Check
Memories: 3:Store 4:Recall 5:Erase
Setup Menu
menu are:
, and
Change: 1:Tx 2:Rx 3:Terr-Intfc
Change limited as Remote M&C active !
Change: 1:Rem M&C 2:Time/Date
which allows access to the configuration
Page 56