Change, Tx, Modulator, Aupc, Tolerance Menu; Change, Tx, Modulator, Aupc, Carrier Lost Action Menu - Paradise Datacom P300 Series Installation & Operating Handbook

This screen allows the target Eb/No to be set. This It is the distant Eb/No when the AUPC mode It is set
to , and the local Eb/No when set to
adjust the Tx power within the Max, Min, and Slew rate limits (once the Eb/No goes outside the
Tolerance window set below) to try and restore this figure.

6.6.23 Change, Tx, Modulator, AUPC, TOLERANCE Menu

Change, Tx, Modulator, AUPC, Tolerance Menu
This sets a `tolerance window` on the monitored Eb/No. The AUPC will only attempt to restore the
monitored Eb/No to the target Eb/No when the monitored Eb/No moves outside the tolerance window.
This It is to prevent the AUPC continuously adjusting the power to compensate for minor normal Eb/No
variations.
When the monitored Eb/No moves outside the tolerance window the AUPC will attempt to restore it back
to the target value (ie not just back inside the tolerance window again).

6.6.24 Change, Tx, Modulator, AUPC, CARRIER LOST ACTION Menu

Change, Tx, Modulator, AUPC, Comms lost action Menu
This screen sets what action the AUPC It is to take locally if it looses communications with the distant
modem (ie presumably there It is a significant fade and the distant demod has lost lock).
The carrier power It is frozen at its current value.
The AUPC delta power It is reset to zero so the carrier returns to its nominal
power.
The AUPC delta power increases to the maximum power limit as set on the
AUPC Max positive delta power screen.
P300H P300 Series Modem Installation and Operating Handbook
Set Eb/No tolerance before AUPC action:
[ 0.5dB] (0.1-25.0dB) ??.?dB (Yes)
Set AUPC power on carrier lost: [Nominal]
1=Freeze 2=Nominal 3=Maximum
. This It is the target Eb/No the AUPC will
Page 78