Denso BHT-300B User Manual page 99

Testing with PING
[5.9]
(1) PING screen
⇓
(PING running screen)
(PING end screen)
(in LAN-support software
On the TEST menu, selecting "9: PING" calls up the screen shown at
left.
[1] RUN PING: Runs PING.
[2] SET PING: Switches to the PING parameter setting screen.
[3] SET DEVICE: Switches to the PING device setting screen.
Select a desired item by using the numerical keys or F5 and F6 keys,
and then press the ENT key.
To return to the TEST menu, press the C key.
On the TEST PING menu, select "1: RUN PING" to call up the screen
shown at left where the current settings are displayed.
The COUNT entry box enclosed with brackets is ready to accept data.
If you want to modify the number of echo requests displayed, enter
the desired value by using the numerical keys.
To delete a single character, press the BS key. To delete the whole
entry you made, press the C key.
Press the ENT key to start PING.
Once PING starts running, the message shown at left will appear.
To stop PING, press the C key.
The PING result may include the following:
OK: Displays the number of echo replies.
[XXXXX]: Echo reply time in milliseconds
NG: Displays the number of errors found during execution of
PING.
TIMEOUT: Displays the number of timeouts (for echo replies) that
took place during execution of PING.
IP: Displays the BHT's IP address during execution of
PING only.
85
Chapter 2 Getting Started the BHT and System Mode
only)