JLG Skytrak 6036 Service Manual page 48

SOME TIRES HAVE THIS INSTRUCTION EMBOSSED IN SIDE WALL:
DRIVING TIRES MUST ROTATE
AS THE ARROW POINTS
(OTHER TIRES MUST ROTATE
IN THE OPPOSITE DIRECTION)
VALVE POSITION FOR
FILLING TIRE WITH
HYDROFILL AND AIR
TIRE
HUB
VALVE POSITION FOR CHECKING TIRE PRESSURE
AND FOR DRAINING HYDROFILL FROM TIRE
Fig. 5.1 Tire Direction of Rotation and Valve Stem Positions for Tire Pressure Check, Fill and Evacuate
NOTE: The calcium chloride hydrofill solution will
corrode a standard tire pressure gauge. Use a
corrosion resistant tire pressure gauge . Be sure
to flush the gauge with clear water after checking
a tire inflated with hydrofill and air.
Before you remove a tire from a wheel, use an
ejector tool to remove the valve core and use
ejector tool and pump to remove calcium chloride
5-3
WHEEL LUG NUT
Section 5. Wheel Assembly, Tires, and Axle
ARROW POINTS TO RIGHT
ON BOOM SIDE OF FORKLIFT
NOTE DIRECTION OF
TREAD PATTERN
MA0211
ARROW POINTS TO LEFT
ON CAB SIDE OF FORKLIFT
solution from the tire.
These instructions cover tire removal and installa-
tion for the standard three piece wheel and for the
optional single piece wheel.
Instructions in italics refer to a tire with an optional
tube. You may use a tube if the tire doesn't
provide an air tight seal.
Model 6036/6036T S/N 9B0499 and Before
MA0212
MA0214
MA0213