JLG Skytrak 6036 Service Manual page 150

d. Inspection, Repair and Replacement
1. Check that rod (13, Fig. 9.17) is straight. If the
rod is bent, install new rod.
2. Inspect inside of the tube (3) for scoring and
other damage. If the tube is damaged,
replace with new tube.
3. Remove small scratches on the rod or inside
of the tube with emery cloth of very fine grit.
Use the emery cloth with a rotary motion.
4. Remove staking burrs from the nut (4) and the
1. Check Valve (2)
2. Plug (2)
3. Cylinder Tube
4. Nut
5. Piston
6. O-ring
7. Piston Seal
8. Gland
9. O-ring
10. Backup Ring
11. Rod Seal
12. Wiper
13. Rod
14. Grease Fitting (2)
15. O-ring (6)
16. Backup Ring (6)
1
9-37
14
2
15
16
4
5
6
7
Fig. 9.17 Frame Tilt Cylinder Exploded View
bottom of the piston (5) with a fine file. Clean
parts with trichlorethylene after repair.
e. Assembly
NOTE: Follow general assembly instructions in
paragraph 9.2c.
1. If removed, install the plugs (2) and grease
fittings (14).
2. Install new O-ring (9, Fig. 9.17), backup ring
(10), wiper (12), and rod seal (11) on gland (8)
as shown in Fig. 9.17.
1
15
16
2
3
Model 6036 S/N 9B0499 and Before
Section 9. Hydraulic System
9
10
11
12
8
9
10
11
12
13
14
MA0581