JLG Skytrak 6036 Service Manual page 104

Section 8. Engine
Whenever you replace a muffler you should also
replace the tail pipe.
Use Exhaust System Sealer at all slip joint con-
nections before assembly.
When installing exhaust parts, make sure there is
sufficient clearance between the hot exhaust parts
and pipes and hoses and wiring that would be ad-
versely affected by excessive heat.
6
2
5
4
1. Muffler
6.
2. Pipe, exhaust
7.
3. Pipe, tail
8.
4. Clamp, T-Bolt
9.
5. Clamp, muffler
10. Pipe, tail
NOTE: Items 7 through 10 are for forklifts with right
side exhaust, SN 8H0289 and after.
Fig. 8.23 Exhaust System for a Naturally Aspirated
Engine
8-18
8
7
5
9
10
3
5
1
PA0382
Gasket, exhaust manifold
Flat
Capscrew, hex head
Nut
When installing an exhaust system be careful to
provide for expansion when the system is hot.
Check complete exhaust system for broken, dam-
aged, missing or mispositioned parts, open
seams, holes, loose connections, and other dete-
rioration which could permit exhaust fumes to
seep into the operators cab. Any damaged areas
must be corrected immediately.
Periodic maintenance of the exhaust system is not
required; however, it is advisable to check the con-
dition of the system when performing other main-
tenance on the forklift.
5
2
4
3
1. Muffler
2. Pipe, exhaust
3. Clamp, T-Bolt
4. Clamp, muffler
5. Gasket, exhaust manifold
Fig. 8.24 Exhaust System for Turbocharged Engine
Model 6036 S/N 9B0499 and Before
7
6
4
8
9
4
1
PA0392
6. Flat
7. Capscrew, hex head
8. Nut
9. Pipe, tail