JLG Skytrak 6036 Service Manual page 183

Section 9. Hydraulic System
e. Assembly
1. If the pump and motor assembly was disas-
sembled, mount the end head assembly (12,
Fig. 9.45) and pump (10) i on the motor (13)
and secure.
2. Install check valve (11) in the end head
assembly (12).
3. Install the solenoid (9) on the housing of the
motor (13) and secure with two screws (9).
4. Connect black terminal cable (7) to the sole-
noid cable terminal and the motor power
terminal.
f. Installation
1. Place the pump and motor assembly on the
frame and support in position.
Model 6036 S/N 9B0499 and Before
2. Secure the pump and motor assembly to the
frame with two 3/8-16 UNC-28 hex head
capscrews (5, Fig. 9.45) and lock washers (6).
3. Connect the supply hose (1) and pump outlet
hose (3) to appropriate pump port fittings.
4. Connect the red electrical cable to the solenoid
power terminal.
5. Connect the yellow ground wire to the end head
assembly (12).
6. Connect the yellow switch wire to the solenoid
switch terminal.
g. Testing
Test operation of steering and emergency brake
pump (para 9.1.6).
9-70