JLG Skytrak 6036 Service Manual page 106

Section 8. Engine
13. Disconnect the engine wire harness at the
following components, Fig. 8.26:
• Starter
• Starter Ground Cable
• Starter Relay
• Neutral Start Switch (on transmission)
• Transmission Temperature Switch
• Low Oil Pressure Sender
• Emergency Pump Oil Pressure Switch
• Water Temperature Sender
• Fuel Run Solenoid
• Alternator
• Thermo Start Plug
Pull harness off of engine and forward on
forklift so it is out of the way.
14. Detach and plug fuel lines as required at fuel
pre-filter and fuel filter.
TO BATTERIES
29
19
37
STARTER
RELAY
19
STARTER
27
29
5
GROUND CABLE
8-20
ENGINE HARNESS
5
ALTERNATOR
WATER TEMP.
SENDER
Fig. 8.26 Engine Harness Connections
15. Detach throttle cable from engine as follows:
(a) Remove cable clamp securing throttle
cable to throttle cable bracket.
(b) Disconnect the throttle cable from the fuel
injection pump.
16. Remove the transmission control cables from
the connector kit on the transmission as
follows:
(a) Remove the cable clamps securing the
control cable to the connector kit, Fig. 4.4.
(b) Disconnect the control cables from the
swivel linkage.
17. Disconnect transmission drive shaft from the
transmission:
(a) Remove transmission cover from forklift.
14
37
ENGINE
6
5
FUEL RUN
SOLENOID
28
15
31
BACKUP
ALARM
Model 6036 S/N 9B0499 and Before
NEUTRAL START SWITCH
(TRANSMISSION MOUNTED)
NOT USED
38
TRANSMISSION
TEMP. SWITCH
18
LOW OIL
PRESSURE
SENDER
16
4
10
EMERGENCY
28
PUMP OIL
34
PRESSURE
SWITCH
MA0381