F Igure 2: Wp-501 Rear Panel - Kramer WP-501 User Manual

Figure 2: WP-501 Rear Panel
# Feature
1 IR OUT
2 VIDEO OUT
3 AUDIO OUT 2
4 AUDIO OUT 1
5 POWER + 12V DC
6 Ring Tongue Terminal
Grounding Screw
7 ETHERNET Port
8 RELAYS Terminal Blocks
9 VGA (PC) OUTPUT
Terminal Blocks
10 RS-232 Port
11 PC 2 IN Terminal Blocks
12 AUDIO IN 2 Terminal
Blocks
13 AUDIO/VIDEO
IN Terminal
14
Blocks
WP-501 - Defining the WP-501
Function
Controls the display device via an IR emitter (for example,
in cases where RS-232 control is not available)
Connect to the video IN of the display device
Connect to he audio input associated with the Video Input
channel of the display device
Identical to the AUDIO OUT 1 port
Connect to the audio input associated with the PC
graphics Input channel of the display device
Identical to the AUDIO OUT 2 port
Connect to power the unit
Connect to grounding wire (optional), (see
Connect to the local computer network for accessing the
stored Web pages, for remote control and management
from the Kramer Site-CTRL software and for remote
configuration file and firmware updates upload
Connect to low-voltage relay-driven devices (from 1 to 2)
Connect to the PC graphics IN of the display device
Connect to the RS-232 connector on the display device
Connect to the PC 2 source (pins ED12 and ED15 pass
the EDID information)
Make sure you use 15-wire VGA cables between the
WP-501 and the PC2 to enable EDID communication
Connect to the unbalanced stereo audio signal of the PC2
source
VIDEO Connect to the composite video source
LEFT,
Connect to the left and right unbalanced audio source
RIGHT
Sec ion 4.1 )
5