Eaton PV240 User Manual page 16

An additional electrical name plate is attached in the bottom plate of the
wiring box as shown in figure 5.3.3.
IMPORTANT
For the PV240 model, the user will be able to use the manual
function of a dip switch in order to down power the PV240 model
into 3800W output. After adjusting is finished, the name plate
should be replaced since the defaulted settings of inverter have
been changed.
The adjusting procedure for down powering a PV240 model
grid-connected PV Inverter should be done by qualified and
authorized service personnel only. Ensure the removal of the
original name plate of unit in order to attach a new name plate at
the same location after unit is adjust to 3800W output power.
Eaton Corporation
Fig. 5.3.3: Wiring Box Name Plate
Page 16 Ver 1.1