Memory Operation; Qmb Channel - Yaesu FT-817ND Operating Manual

M
EMORY
QMB Channel Storage
1. Tune in the desired frequency and set the operating mode and bandwidth. If this is an
FM channel, set up any required CTCSS/DCS and repeater shift configurations.
2. Press and hold in the
audible confirmation that the data has been stored into the QMB memory.
Pressing the
PMS ] will also store a frequency into the QMB register.
RCL, PMS RCL RCL PMS PMS
RCL RCL PMS
QMB Channel Recall
1. Press the key momentarily, then rotate the
Function Row 3 [ STO
( RCL RCL ) key momentarily to recall the QMB memory. "QMB
2. Press the
RCL RCL
RCL
at the upper right corner on the LCD.
( RCL RCL ) key once more to return to the previous frequency (either a VFO
3. Press the
RCL RCL RCL
frequency or a Memory channel).
If you move the
change frequencies as if you were in a "VFO" mode. You also can change operat-
ing mode by pressing the
will appear in the display, where "MT
key once more to return to the originally-stored QMB frequency.
44
O
PERATION
QMB C
key until a double "beep" is heard. The second beep provides
( A A A A A /B B B B B ) key momentarily while in Operating Function Row 3 [ STO
PMS ] appears on the display.
STO STO, RCL STO RCL RCL, PMS RCL PMS PMS
STO RCL PMS
knob or
or
MT MT
MT" represents "Memory Tuning." Press the MT
HANNEL
knob, as needed, until Operating
knob while in the QMB mode, you can
key. When this is done, the "MTQMB
FT-817
ND
STO STO
STO STO,
QMB" will appear
QMB QMB
QMB
MTQMB" MTQMB MTQMB MTQMB
( RCL RCL )
RCL RCL
RCL
Operating Manual