Am Transmission; Split Frequency Operation - Yaesu FT-817ND Operating Manual

T
RANSMITTER
The FT-817 utilizes low-level amplitude modulation of an early stage for transmission
ND
purposes. This capability is primarily provided for emergency use only, as low-power op-
eration typically utilizes more efficient transmission/reception modes.
The AM carrier level is preset to 1.5 Watts during alignment at the factory, and should not
require further adjustment. It is important to remember that AM transmission requires that
power must be distributed among the carrier and voice sidebands; therefore, if excessive
carrier power is used, there will be insufficient power available for the information-carry-
ing voice sidebands.
The AM microphone gain is preset at the factory to a value which typically provides good
audio. If you need to modify the microphone gain in the AM mode, use Menu #05 (AM
MIC). See page 60 for details.
MIC MIC
MIC MIC
This transceiver provides convenient split-frequency operation, using the VFO-A and VFO-
B, for DX working and other operating situations requiring unique split frequency pairs.
The example below will describe a typical split-frequency DX situation on the 20-meter
band, with a DX station transmitting on 14.025 MHz, listening 10 kHz higher in the band.
1. Set VFO-A to 14.035.00 MHz CW (DX station's listening frequency).
2. Press the key momentarily, then rotate the
Function Row [ A A A A A /B B B B B , A=B
( A A A A A /B B B B B ) key momentarily to select VFO-B.
3. Press the
4. Tune the VFO-B frequency to 14.025.00 MHz (DX station's transmitting frequency).
( SPL SPL ) key momentarily. The transceiver will now transmit using the VFO-
5. Press the
SPL SPL
SPL
A frequency, and will receive using the VFO-B frequency. The "
on the display.
6. To listen to the pile-up calling the DX station (so as to align your frequency more closely
to that of the station being worked by the DX), press the
VFOs. You will now be tuning in the vicinity of 14.035 MHz, and you can zero in on the
DX station's listening frequency by tuning in on the station in QSO with the DX. Press
( A A A A A /B B B B B ) key again to return to reception on the DX station's frequency.
the
( SPL SPL ) key once more to cancel split operation; the "
7. Press the
SPL SPL
SPL
pear from the display.
42
O
PERATION
AM T
RANSMISSION
S F
PLIT REQUENCY
SPL ] .
A=B A=B, SPL A=B SPL SPL
A=B SPL
O
PERATION
knob, as needed, until Operating
( A A A A A /B B B B B ) key to reverse the
FT-817 Operating Manual
ND
AM AM
AM AM
" icon will appear
" icon will disap-