Yaesu FT-817ND Operating Manual page 68

M O
ENU
Menu Item 36 [ MIC KEY MIC KEY ]
MIC KEY MIC KEY
MIC KEY
Function: Enable/disable CW keying by the microphone's [ UP ] / [ DWN ] keys.
Available Values: OFF/ON
Default: OFF
When this Menu Item is set to "ON," press the microphone's [ UP ] key to send a "dot," and
press the microphone's [ DWN ] key to send a "dash" (while the built-in electronic keyer is
engaged).
Menu Item 37 [ MIC SCAN MIC SCAN ]
MIC SCAN MIC SCAN
MIC SCAN
Function: Enable/disable scanning access via the microphone's [ UP ] / [ DWN ] keys.
Available Values: OFF/ON
Default: ON
Menu Item 38 [ OP FILTER OP FILTER ]
OP FILTER OP FILTER
OP FILTER
Function: Enable the optional filter (CW or SSB) path.
Available Values: OFF/SSB/CW
Default: OFF
After installing the optional filter, set this Menu Item to define the signal path correspond-
ing top the filter you have installed.
Menu Item 39 [ PKT MIC PKT MIC ]
PKT MIC PKT MIC
PKT MIC
Function: Adjust the audio input level from the TNC during 1200 bps Packet operation.
Available Values: 0 ~ 100
Default: 50
Menu Item 40 [ PKT RATE PKT RATE ]
PKT RATE PKT RATE
PKT RATE
Function: Set the transceiver's circuitry for the Packet baud rate to be used.
Available Values: 1200/9600 bps
Default: 1200 bps
Menu Item 41 [ RESUME RESUME ]
RESUME RESUME RESUME
Function: Set the delay time for scanning resumption.
Available Values: OFF/3/5/10 seconds
Default: 5 sec
When this Menu Item set to "OFF," the scanner stops (without restarting) until you press
( SCN SCN ) key (or the microphone's [ UP ] / [ DWN ] keys).
the
SCN SCN
SCN
Menu Item 42 [ RPT SHIFT RPT SHIFT ]
RPT SHIFT RPT SHIFT
RPT SHIFT
Function: Set the magnitude of the Repeater Shift.
Available Values: 0 ~ 99.99 MHz
Default: Depends on transceiver version, and the band in use.
Each band's repeater shift (HF/50/144/430 MHz) may be set independently.
66
PERATION
FT-817 Operating Manual
ND