Yaesu FT-817ND Operating Manual page 66

M O
ENU
Menu Item 27 [ DIG SHIFT DIG SHIFT ]
DIG SHIFT DIG SHIFT
DIG SHIFT
Function: Define the carrier frequency offset during DIG (USER-L or USER-U) mode
operation.
Available Values: –3000 ~ +3000 Hz
Default: 0 Hz
Menu Item 28 [ EMERGENCY EMERGENCY ] : USA Version only
EMERGENCY EMERGENCY
EMERGENCY
Function: Enable Tx/Rx operation on the Alaska Emergency Channel, 5167.5 kHz.
Available Values: OFF/ON
Default: OFF
When this Menu Item is set to "ON," the spot frequency of 5167.5 kHz will be enabled. To
get to this frequency, use the
be found between the Memory channel "M-PU
Use of this frequency is restricted to amateurs operating in (or within 92.6 km of)
the U.S. State of Alaska, and it is to be used for emergency communications only
(involving the immediate protection of life or property).
Menu Item 29 [ FM MIC FM MIC ]
FM MIC FM MIC
FM MIC
Function: Adjust the microphone gain level for the FM mode.
Available Values: 0 ~ 100
Default: 50
Menu Item 30 [ FM STEP FM STEP ]
FM STEP FM STEP FM STEP
Function: Select the tuning steps for the
Available Values: 5/6.25/10/12.5/15/20/25/50 kHz
Default: 5 kHz (depends on operating band and transceiver version)
Menu Item 31 [ ID ID ID ID ID ]
Function: Store your callsign into the CW identifier. Up to eight characters may be stored.
The storage procedure is as follows:
1. Press the
appear below the first character location of the callsign).
2. Rotate the
the knob one click clockwise to save the first letter/number and move to the
next entry position.
3. Repeat the previous step as many times as necessary to complete your callsign.
4. Press the
Default: YAESU
64
PERATION
knob to navigate; the Alaska Emergency Channel will
knob momentarily to initiate callsign storage (an "under-bar" will
knob to select the first letter/number of your callsign, then rotate
knob to save your completed callsign and exit.
M-PU" and "M-001
M-PU M-PU M-PU M-001." M-001 M-001 M-001
knob on the FM mode.
FT-817 Operating Manual
ND