Entering A Point Of Interest - Mercedes-Benz COMAND Operating Instructions Manual

Entering a point of interest

66
To change the sequence of the
X
waypoints: select
menu by turning cVd the COMAND
controller and press W to confirm.
The entries are swapped.
To delete waypoints: select the symbol
X
for waypoint 1 or 2 in the waypoint menu
by turning cVd the COMAND controller
and press W to confirm.
Select Delete and press W to confirm.
X
i
You can delete a waypoint directly after
entry using this menu item.
Accepting waypoints for the route
Select Start in the waypoint menu by
X
turning cVd the COMAND controller and
press W to confirm.
The route is calculated with the entered
waypoints.
i Cont.
is displayed instead of
Calculate Alternative Routes
activated in the navigation menu
( page 82), option 2.
Y
In the example, there are both waypoints 1
and 2.
Entering a point of interest
Calling up the points of interest menu
Points of interest are predefined destinations
within categories, e.g. a gas station in the
AUTOMOTIVE category.
Swap in the waypoint
Start when
is
You can look for points of interest:
in the vicinity of the destination
R
near the current vehicle position
R
in the vicinity of another city
R
using its name
R
using a phone number
R
You can also select points of interest in the
map that are available on the map view
shown.
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Destination in the navigation
X
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
Select From POIs and press W to confirm.
X
A menu appears.
Points of interest menu ("Search by name"
selected)