Route Overview - Mercedes-Benz COMAND Operating Instructions Manual

Route guidance
84
The example shows:
the destination O
R
two waypoints
R
the relevant information on distance,
R
estimated time of arrival and estimated
remaining driving time
i
If a mobile phone is connected to
COMAND ( page 116) and a phone
Y
number is included in the destination
information, you can call it.
To call up further destination
X
information: turn cVd the COMAND
controller.
To close the destination information:
X
slide XVY the COMAND controller or press
the k button.

Route overview

You can use the route overview to move along
the active route section by section and view
information and details about each section of
the route.
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Route in the navigation system
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Route Browser
X
confirm.
At the top of the display, you will see
information about the highlighted route
section, for example the distance to be driven
on the road and road designation. The
highlighted route section is marked in white
with a red border on the map.
To view the next or previous route
X
section: select Next
press W to confirm.
i
X
X
You can see the route before starting your
journey. This function is only available when
the vehicle is stationary.
X
X
X
X
and press W to
X
X
or Previous and
If the first or last route section is
highlighted, you cannot select
Next.
To zoom in or out of the map: select N
or M and press W to confirm.
To close the route overview: select
Back and press W to confirm.
Route display
To switch on navigation mode: press the
Ø function button.
To show the menu: press W the COMAND
controller.
Select Route in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Route Demonstration
W to confirm.
The map with the crosshair appears.
To get to the destination: press W to
confirm the highlighted symbol.
To stop the route display: confirm the
Ë symbol by pressing W.
Previous or
and press