Map Information - Mercedes-Benz COMAND Operating Instructions Manual

Map operation and settings
102
Map information in the display
During route guidance, you can have map
information shown at the bottom edge of the
display.
Showing text information
To show the menu: press W the COMAND
X
controller.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Map Settings
X
confirm.
The map settings menu appears.
Select Text Information On Map
X
press W to confirm.
A # dot indicates the current setting.
Select Arrival Time /
X
Current Street,
None and press W to confirm.
To exit the menu: slide XVY the COMAND
X
controller.
Arrival time/distance to the destination
Arrival time/distance display switched on
Icon for destination
:
Distance to the destination
;
and press W to
and
Distance,
Geo-coordinates or
Icon for estimated time of arrival
=
Estimated time of arrival
?
You can only see this display during route
guidance. While scrolling the map
( page 61), you will see additional data, e.g.
Y
road names, depending on the crosshair
position, if the digital map supports this data.
i
During route calculation, or if the vehicle
is traveling on a non-digitized road, the
linear distance to the destination is shown.
In this case, the display will be grayed out.
Road display
Road display active
Road names or numbers, e.g. for freeways
:
Geo-coordinate display
Geo-coordinate display active
Current height above average sea level
:
(rounded)
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.