Recording - Mercedes-Benz COMAND Operating Instructions Manual

Example: route display stopped
Road name and city display when route
:
display has been stopped
Distance of the crosshair from current
;
vehicle position
To get to the current vehicle position:
X
press W to confirm the symbol for the
current vehicle position.
To change the map scale: select
X
and press W to confirm.
The scale bar appears.
Turn cVd the COMAND controller and
X
press W to confirm.
Recording the route
Notes
If you have activated COMAND and the SD
memory card has been inserted, you should
not take it out of the slot.
When you record a route, COMAND uses so-
called support points and displays the route
as a series of lines. If the route is then
calculated, COMAND attempts to align the
recorded route with the digital map.
The support points of the route may not be on
a digitized road.
This is often the case for routes that have
been calculated using map data from other
sources.
Calling up the Routes menu
Insert the SD memory card (
X
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Select Record
X
Scale
Starting/ending recording
To start recording: select
X

Recording

cVd the COMAND controller and press
W to confirm.
During the recording, the recorded route is
shown behind the current vehicle position
with gray strokes (symbol for tire tracks).
To end recording: select
X
Recording
Route guidance
page 157).
Y
in the navigation
Routes.
Start
in the Routes menu by turning
Stop
in the Routes menu by turning
85
Z