Map Operation And Map Setting; Geo-Coordinate Display - Mercedes-Benz COMAND Operating Instructions Manual

Map operation and map setting

106
Selecting map information
Map information in the display
During route guidance, you can have map
information shown at the bottom edge of the
display.
To show the menu: press W the COMAND
X
controller.
Select Navi Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Map Settings Map Settings
X
confirm.
The map settings menu appears.
Select Text Information On Map Text Information On Map
X
press W to confirm.
A # dot indicates the current setting.
Select Arrival Time / Arrival Time / Distance
X
Current Current Street Street,
None None and press W to confirm.
To exit the menu: slide XVY the COMAND
X
controller.
Arrival time/distance to destination display
Icon for destination O
:
Distance to destination
;
Icon for estimated time of arrival Ñ
=
Estimated time of arrival Ñ
?
and press W to
and
Distance,
Geo-coordinates Geo-coordinates or
You can only see this display during route
guidance.
While moving the map, you will see additional
data, depending on the crosshair position, if
the digital map supports this data. This might
be a street name, for example.
During route calculation, or if the vehicle is
traveling on a non-digitized road, the linear
distance to the destination is shown. In this
case, the display will be grayed out.
Road display
Road names or numbers, e.g. for
:
highways

Geo-coordinate display

Current height above average sea level
:
(rounded to the nearest 10 m)
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
During the "Move map" function, you will see
the geo-coordinates of the crosshair position.