Product Features; Local Codes - Procom MN200EBC Owner's Operation And Installation Manual

SAFETY INFORMATION
WARNING: Do not use
any accessory not approved
for use with this heater.
WARNING: Any change to
this heater or its controls can
be dangerous.
WARNING
Modeles MN200EBC MN200EHBC
MN300EBC MN300EHBC are
equipped for Natural Gas. Field
conversion is not permitted.
Due to high temperatures, heater
should be kept out of traffic and
away from furniture and draperies.
Front surface of heater becomes
very hot when running heater.
Keep children and adults away
from hot surface to avoid burns
or clothing ignition. Heater will
remain hot for a time after shut
down. Allow surface to cool
before touching.
Do not place clothing or other
flammable material on or near
the appliance. Never place any
objects on the heater.
C are fu l ly s up e rv i se
children when they are in the
same room with heater.
Make sure grill guard is in
place before running the heater.
Keep the appliance area clear
and free from combustible
materials, gasoline, and other
flammable vapors and liquids.
1. This appliance is only for use
with the type of gas indicated
on the rating plate. This
appliance is not convertible for
use with other gases.\
2. If you smell gas
l Shut off gas supply.
l Do not try to light any appliance.
l Do not touch any electrical
switch, do not use any phone in
your building.
l Immediately call your gas sup-
plier from a neighbor's phone.
F o l l o w t h e g a s s u p p l i e r ' s
instructions.
l If you cannot reach your gas
supplier, call the fire department.
3. This heater shall not be in stalled
in a bedroom or bathroom.
4. This heater needs fresh, outside
air ventilation to run properly. This
heater has an Oxygen Depletion
Sensor (ODS) safety shutoff
system.The ODS shuts down the
heater if not enough fresh air
is available. See Fresh Air for
Combustion and Ventilation
pages 5 and 6.
5. Keep all air openings in front
bottom of heater clear and free of
debris. This will insure enough air
for proper combustion.
6. If heater shuts off. Do not relight
until you provide fresh, outside
air. If heater keeps shutting off,
have it serviced.
7. Do not operate
l W here flammable liquids or
vapors are used or stored
l Under dusty conditions
8. Before using furniture polish,
wax, carpet cleaner, or similar
yo un g
p ro d u c ts, t u rn
heated, the vapors from these
products may create a white
powder residue within burner
box or on adjacent walls or
furniture.
9. Do not use heater if any part
has been under water. Immedi-
ately call a qualified service tech-
nician to inspect the room heater
and to replace any part of the
control system and any gas con-
trol which has been under water.
10.Turn off and unplug heater and
let cool before servicing. Only a
qualified service person should
service and repair heater.
11.Operating heater above elevations
of 4,500 feet could cause pilot
outage.

PRODUCT FEATURES

(See Figure 1,page 4)
SAFETY PILOT
This heater has a pilot with an
Oxygen Deplet ion Senso r(ODS)
safety shutoff system.
The ODS/pilot shuts off the heater
if there is not enough fresh air.
AUTOMATIC IGNITION
SYSTEM
This heater is equipped with an
automatic control system.
This system requires no matches,
or batteries to light heater.
TOUCH PAD
THERMOSTATIC HEAT
CONTROL
and
This heater has a control module with
a thermostat sensing
temperrature with touch pad. This re-
sults in the greatest heater comfort
and may result in lower gas bills.
MANUL OVERRIDE
CONTROL SYSTEM
(MN200EHBC, MN300EHBC)
There are two control systems,
electric and manual overide.If no
electric power is available,you can
operate heater by manual overide.

LOCAL CODES

h eat er o f f . If
This heater is designed for vent-free
operation. Some state and local
codes prohibit the use of vent-free
heater.
3
bulb. set