Setting Up - Christie Lcd projector User Manual

Setting Up

• There are 3 ways of setting the projector up: front projection, overhead projection and rear projection.
• By adjusting the zoom lens, you can choose the screen size as shown below.
(Front projection)
Offset (O)
Projection distance (L)
Screen Size
(inch)
* Offset is the distance from the middle of the projection lens to the bottom edge of the screen.
* "Screen Size (inch)" is the diagonal length of the screen.
* 31-inch screen size is available only for wide screen and the projection distance is 1.4 m.
Adjustment
• Adjust the height of the projector using the 2 adjusters on the front.
• If the relation between the position of the projector and the screen is not correct, the image will be distorted and blurred.
1
Lift the front of the projector while
pressing the two adjustment levers on
the side of the projector.
Adjustment lever
Adjuster
Note
• If you wish to lower the projector to its original position before storing it, press the adjustment levers and slowly lower the
projector. It can then be stored easily.
Offset (O)
Screen Size
Width
Height
(cm)
(cm)
40 61
60 91
80 122
100 152
150 229
200 305
250 381
300 457
2
When the desired angle is reached,
release the adjustment levers to fix
the adjusters in that position.
(Overhead projection)
Projection distance (L)
Projection
distance L
(m)
81 1.4 – 1.9
122 2.1 – 2.8
163 2.9 – 3.8
203 3.6 – 4.7
305 5.4 – 7.1
406 7.3 – 9.4
508 9.1 – 11.8
610 10.9 – 14.1
Offset O
(cm)
3 – 58
5 – 87
6 – 116
8 – 145
11 – 217
15 – 290
19 – 362
23 – 434
3
Turn the adjusters for fine adjustment.
Up Down
15