Omron V750-BA50D04-SG-MY User Manual page 83

Operation Settings [Programmable Output] (GETO/SETO)
Code Content
Output port #1 function
OT1
setting
Output port #2 function
OT2
setting
Output port #3 function
OT3
setting
Output port #4 function
OT4
setting
User Setting Value
Format: Timing(S)OutputTime(S)Condition
Timing
00:None
(User input)
11:RUN output
(The reader is running normally.)
12:ERR output
(The reader stopped with error.)
20:COM output
(The reader is communicating.)
2n:ATn Current antenna(s) (n=1 to 4)
(The reader is communicating
with specified antenna)
31:NML
(Evaluated normal completion)
32:ERC
(Evaluated completion with error
occurring)
OutputTime
10 to 9990 [ms]
0 (Status kept until upcoming evaluation.)
- Note: Output time is effective only for NML/
ERC setting.
Condition
-Note: Output time is effective only for NML/
ERC setting.
- Note: If the condition is omitted, output
signal shall be on without condition.
* Refer to the following list.
Same as OT1
Same as OT1
Same as OT1
83 of 135
Factory Settings
(None)
(None)
(None)
(None)