Omron V750-BA50D04-SG-MY User Manual page 79

(Smoothing buffer size)
Omit no tag response
ONR
(1) SET Communication (SETC)
This command writes the communication settings in the reader. While the command is being executed,
setting conditions in the reader are changed. To write the setting data into the nonvolatile memories in the
reader, SAVE command (SAVE) shall be executed. The new setting shall be enabled at the upcoming
startup.
Command
SETC(S)Param1=Value1(S)...(S)ParamN=ValueN<LF>
Note:
･ It specifies a parameter connecting a setting item to a setting value. ('The setting
item does not have to be prepended with ' -' .)
･ No space shall be put in from the beginning of the setting item to the end of the
setting value unless setting item is ft1 or ft2.
･If you specify ft1 and ft2 for filtering, set ft1, ft2 and fte at one sequent action. ft1 and
ft2 shall be always followed by Filtering Enable (fte). If you specify them in one
command SETC, firstly put ft1 and ft2 then fte in order. If you change the filtering
conditions with ft1 and/or ft2, the filtering function will be temporarily Disabled.
･ If the setting item is ft1 or ft2, the five items shall be specified with space separation
between each item. Instead of space, enclosing double quotations is not allowable.
･ In a single command, multiple setting items can be specified by separating with
space. 2 or more character spaces are acceptable for indicating separation.
Response
SETC[RC]<LF>
*(S) Space Character
Example 1) When [Antenna port #1 power; 10, Gen2 session for Once Mode Reading; 1] is specified:
[Tx] SETC pw1=10 ss1=1<LF>
[Rx] SETC0000<LF>
Example 2) When [Filter; 1 or 2, Filter1's Bank; 1, Pointer; 8, Length; 2, Data; C0(11b), Filter2's Bank 1,
Pointer; 20, Length;16 ,Data; 125A(00010010 01011010b)] is specified:
[Tx] SETC ft1=0 1 8 2 C0<LF>
[Rx] SETC0000<LF>
[Tx] SETC ft2=0 1 20 16 125A<LF>
[Rx] SETC0000<LF>
[Tx] SETC fte=1|2<LF>
[Rx] SETC0000<LF>
[RC]: Response Code
-Max: 999
-Step: 1
Choice
0:Disable / 1:Enable
79 of 135
0:Disable