Port; Turning On / Off The Power - EverFocus ECOR960 4F2 User Manual

ECOR960 4F2 / 8F2 / 16F2
2.2.3 RS-485 Port
The RS-485 port, located on the rear panel of the DVR, can be used to connect to an RS-485
keyboard, such as EverFocus' EKB500, for controlling PTZ cameras. For details on the RS-485
configurations on the DVR, please refer to 6.9.5 I/O Control. This figure uses ECOR960 16F2 DVR as
an example.
Rear View
RS-485 Port
EKB500
RS-485 RJ-45 Cable
PTZ Camera 1~16
Connector Box
Figure 2-14
2.3

Turning On / Off the Power

Before powering on the DVR, please make sure the internal HDDs have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the DVR.
To turn on the power, connect the supplied Power Cord to the power outlet and turn on the
Power Switch. All of the LED indicators on the front panel will light up. The DVR will automatically
run an internal process, when the process is complete, the LED indicators will turn off, and the
POWER LED will remain light up in green. And then you can start operating the DVR.
To turn off the power, please go to OSD Root Menu > System Setting > Miscellaneous setting page,
and click Shutdown (refer to 6.9.7 Miscellaneous). After the message pops up as below, you can
now turn the Power Switch to the "Off" position.
Figure 2-15
18